E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Center Mounted Brake Lamp: All Technical Service Bulletins
A/T - Shifts From Park Without Brake Pedal Depression
Article No.
96-8-18
04/08/96
TRANSMISSION - ALL - VEHICLE CAN BE SHIFTED OUT OF "PARK" WITHOUT DEPRESSING BRAKE PEDAL - ECONOLINE
CUTAWAYS ONLY AND F-SERIES BUILT THROUGH 2/28/95
LIGHT TRUCK:
1994-95 BRONCO, ECONOLINE, F SUPER DUTY, F-150-350 SERIES
ISSUE:
The customer may be able to shift the vehicle out of "Park" without depressing the brake pedal on some vehicles. This may occur if no high mount
stoplamp is installed or the bulb filament is either missing or open, simulating the brake pedal being depressed.
ACTION:
Install a jumper harness with a resistor to simulate the presence of a high mount stoplamp or replace the high mount stoplamp if the bulb is open. Refer
to the following Service Procedure for details.
SERVICE PROCEDURE - ECONOLINE
1.
If a high mount stoplamp is installed, check to make sure the bulb filament is not missing or open. Repair as required.
2.
Locate the -14A200- wire harness along the B-pillar behind the driver's seat.
3.
Locate brake test connector C358, Figure 1. This is a 2-way gray connector.
4.
Install the jumper into the connector.
5.
Wrap the main body wire harness with polyken tape. This will hold the connector in place and prevent any rattles of the connector to the B-pillar.
SERVICE PROCEDURE - F-SERIES
1.
Check to make sure the high mount stoplamp bulb filament is not missing or open. Repair as required.
2.
Locate the -14334- wire harness in the rear of the cab near the center high mount stoplamp.
