E 350 Van V8-7.3L DSL Turbo VIN F (1995)
Safety Belts, Front Outboard Position, Bucket and Captain's Chairs - Cutaway Only
Removal and Installation
1. Remove shoulder strap guide cover.
2. Remove the upper anchor bolt attaching D-ring using Seat Belt Bolt T77L-2100-A (#50 Torx(R))
3. Remove safety belt retractor cover safety belt retractor cover and, using the Seat Belt Bolt Bit, remove bolt attaching front safety belt retractor and
tongue.
4. Remove the lower anchor bolt attaching front safety belt to front floor pan using the Seat Belt Bolt Bit.
5. Remove front door scuff plate to access bolt anchoring front safety belt. Remove bolt.
6. Remove front safety belt retractor and tongue. For installation, follow removal procedures in reverse order.
-
Check sealer around floor anchor bolt holes and add Ford Caulking Cord D6AZ-19560-A.
-
Tighten anchor bolts to 30-40 Nm (22-29 lb-ft).
-
Check the restraint system for proper operation.