Transmission Neutral Safety Switch Service and Repair for E350 Van (1995)
Neutral Safety Switch: Service and Repair
E4OD Transmission
REMOVAL AND INSTALLATION
1. Apply parking brake, then place gear selector lever in Neutral position.
2. Ensure transmission shift cable is correctly adjusted, then loosen Park/Neutral position switch retaining bolts.
3. Insert Gear Position Sensor Adjuster tool No. T92P-70010-AH, or equivalent, on Park/Neutral position switch into the three slots provided on the
switch actuator and terminal plate.
4. Leaving the alignment tool in place, torque switch retaining bolts to 6 ft lb.
5. Remove alignment tool, adjustment can be verified visually by making sure the line etched in the housing are in a straight line when the
Park/Neutral position switch is centered in neutral.
6. Check the operation of the Park/Neutral position switch. The back-up lamps should operate only with the transmission selector lever in reverse.
The vehicle should only start with the selector lever in park or neutral.