E 350 Van V8-7.3L DSL Turbo VIN F (1995)
10. Install two dowel pins and spring into housing. Spring must be inserted with dished surface facing upward.
11. Lubricate inner and outer O-ring seals with power steering fluid, then install seals on lower pressure plate.
12. Install lower pressure plate into housing and over dowel pin with O-ring seals facing toward front of pump. Position assembly on C-clamp. Place
seal installer tool No. T78P-3733-A3, or equivalent, into rotor shaft hole and press on lower plate lightly until it bottoms in pump housing. This
will seat outer O-ring seal.
Fig. 6 Assembling Cam, Slippers And Rotor
13. Install cam, rotor and slippers and rotor shaft assembly into pump housing over dowel pins. When installing assembly into pump housing, stepped
holes must be used for dowel pins and notch in cam insert must be toward reservoir and approximately 180 degrees opposite square mounting lug
on housing.
Upper Pressure Plate Installation
