E 350 Van V8-7.3L DSL Turbo VIN F (1995)
a. Install outer seal onto intermediate piston with seal lip facing towards cylinder.
b. Install intermediate/overdrive inner seal into cylinder bore with seal lip facing towards cylinder.
c. Install overdrive outer and inner seals with seal lip facing towards cylinder.
d. Return spring finger must be facing up.
Low Reverse Clutch
WITH C6
REMOVAL
CAUTION: All parts must be handled carefully to avoid nicking or burring the bearing or mating surfaces. Lubricate all internal parts with clean
automatic transmission fluid before assembling them. Do not use any other lubricants except on gaskets and thrust washers. These may be coated with
petroleum jelly to facilitate assembly. Always use new gaskets and seals when assembling transmission.
1. Remove inner and outer seal from clutch piston.
INSTALLATION
1. Dip new seals in transmission fluid and install seals on piston.
One-Way Clutch, A/T
Disassemble
CAUTION: All parts must be handled carefully to avoid nicking or burring the bearing or mating surfaces. Lubricate all internal parts with clean
automatic transmission fluid before assembling them. Do not use any other lubricants except on gaskets and thrust washers. These may be coated with
petroleum jelly to facilitate assembly. Always use new gaskets and seals when assembling transmission.
One-Way Clutch Assembly
1. Remove snap ring and bushing from rear of low reverse hub.
2. Remove rollers from spring assembly, then remove spring assembly from hub.
3. Remove remaining snap ring from hub.
Assemble
1. Install snap ring in forward snap ring groove in hub, as shown in the One-Way Clutch Assembly image.
2. Position hub on bench with forward end down.
3. Install one-way clutch spring on top of snap ring.
4. Install a roller into each of spring assembly compartments.
5. Install bushing on top of spring assembly, then install snap ring.
Overdrive Clutch
OVERDRIVE RING GEAR AND CENTER SHAFT - WITH E4OD
REMOVAL
