E 450 V10-6.8L (2008)
Front Bumper: Service and Repair
BUMPER - FRONT
Removal and Installation
1. Remove the valence panel in the following sequence.
1
Remove the 8 pushpin retainers.
2
Remove the 7 front bumper-to-valence panel screws.
3
Remove the A/C condenser air deflector.
4
Remove the wiring harness retainer for the block heater cord.
2. NOTE: An assistant is required to remove the front bumper.
Remove the front bumper in the following sequence.
1
Remove the 4 nuts.
2
Remove the 4 bolts and remove the bumper.
-
To install, tighten to 80 Nm (59 lb-ft).
3. To install, reverse the removal procedure.