E 450 V10-6.8L (2008)
Part 2
Special Tool(s)
Special Tool(s)
Removal and Installation
All doors
1. If equipped, remove the door trim panel.
2. If equipped, position the watershield aside.
3. Remove the 2 nuts, the interior door handle, and bezel.
4. NOTE: Use the special tool to install the door lock actuator rivet.
If equipped, remove the door lock actuator rivet.
Side door
5. Disconnect the door lock cylinder actuating rod.
6. Disconnect the exterior door handle actuating rod.
Side Door With E-Guard Cargo Protection
7. NOTE: View of the door lock cylinder cover is from the bottom.
Release the 2 tabs on the door lock cylinder cover and slide it off the door lock cylinder.