E 450 V10-6.8L (2008)
Seat Back: Removal and Replacement
Seat Backrest - Front
SEAT BACKREST - FRONT
Removal and Installation
WARNING:
-
Never probe the electrical connectors on safety belt buckle/retractor pretensioners or adaptive load limiting retractors. Failure to follow
this instruction may result in the accidental deployment of the safety belt pretensioners or adaptive load limiting retractors, which
increases the risk of serious personal injury or death.
-
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious
personal injury or death.
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
1. Remove the seat.
Seats with lumbar
2. Pull and remove the lumbar adjust knob.
3. Remove the side shield screw behind the lumbar adjust knob.
Seats with a cushion inboard side shield
4. Remove the cushion inboard side shield rear screw from under the seat.