E 450 V10-6.8L (2008)
3. NOTE: The anti-rotation tab must be correctly aligned for correct installation.
Remove the bolt and detachable safety belt buckle.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Remove the RH armrest.
-
Release the hook-and-loop at the rear of the armrest trim cover and partially invert to access the armrest bolt.
-
Remove the armrest bolt and armrest.
-
To install, tighten to 35 Nm (26 lb-ft).
-
Remove the shim.
-
To install, position the shim to the armrest stop post.
5. Remove the 3 screws and LH cushion side shield.
6. Remove the backrest pivot bolt.
-
To install, tighten to 25 Nm (18 lb-ft).
7. WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The
recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this
instruction may result in serious personal injury.
Remove the 2 recliner-to-backrest bolts.
-
To install, tighten to 48 Nm (35 lb-ft).
8. Lift and slide the backrest from the recliner and remove.
9. To install, reverse the removal procedure.
