E 450 V10-6.8L (2008)
6. Remove the plastic insulator.
7. Remove the manual lumbar assembly.
1
Remove the 2 tie straps.
2
Push the bottom of the lumbar assembly to the right and release the retainers.
3
Spread the wires at the top and release the lumbar assembly.
4
Route out the cable and remove the lumbar assembly.
8. WARNING: Use care when the seat back frame is removed and when releasing the recliners from a backrest upright position. The
recliners are spring-loaded, which may cause the recliner upper arms to fold with significant speed/force. Failure to follow this
instruction may result in serious personal injury.
Remove the 2 bolts and recliner.
-
To install, tighten to 48 Nm (35 lb-ft).
