E 450 V10-6.8L (2008)
3. Remove the backrest trim cover.
-
Route out the safety belt.
4. Remove the backrest foam pad.
5. Remove the 2 screws and safety belt guide bracket.
-
To install, tighten to 10 Nm (89 lb-in).
6. Remove the bolt and center safety belt retractor.
-
To install, tighten to 51 Nm (38 lb-ft).
7. To assemble, reverse the disassembly procedure.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
-
Verify the safety belt retractor operates without excessive effort or binding.
Seat Backrest - Rear, Bench, 4-Passenger
SEAT BACKREST - REAR, BENCH, 4-PASSENGER
