E 450 V10-6.8L (2008)
7. Disconnect the power seat motor jumper harness electrical connector.
8. NOTE: Note the connector locations and wire harness routing for installation.
Separate the electrical connector pin-type retainers from the riser and remove the power seat wire harness.
All seats
9. NOTE:
-
Note the connector locations and wire harness routing for installation.
-
LH shown, RH similar.
Detach the safety belt buckle and pretensioner electrical connector from the seat riser.
10. Separate the riser from the seat track.
11. Remove the safety belt buckle and pretensioner.
1
Remove the bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
2
Separate the safety belt buckle and pretensioner from the seat track.
3
Route out the wire harness and remove the safety belt buckle and pretensioner.
12. To install, reverse the removal procedure.
