E 450 V10-6.8L (2008)
1. Depower the SRS.
2. Remove the 2 driver air bag module bolt caps (1 shown) from the steering wheel.
3. Remove the 2 driver air bag module bolts (1 shown).
-
To install, tighten to 6 Nm (53 lb-in).
4. Disconnect the horn electrical connector.
5. CAUTION: The driver air bag module electrical connectors are unique and cannot be reversed when connected to the driver air bag
module. Match the electrical connector key to the keyway in the driver air bag module. Do not force the electrical connectors into the
driver air bag module. Damage to the connector or component may occur.
Disconnect the driver air bag module electrical connector and remove the driver air bag module.
6. To install, reverse the removal procedure.
7. Repower the SRS.
