E 450 V10-6.8L (2008)
Part 2
Removal
NOTE:
-
The air bag warning indicator illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
A repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
1. Remove the driver air bag module.
2. Pull to release the retaining clips and remove the steering column opening lower finish panel.
3. On the steering column opening lower finish panel reinforcement, detach the pin-type retainer and remove the electrical connector.
4. On the steering column opening lower finish panel reinforcement, remove the 2 screws and the data link connector (DLC).
5. Remove the 6 bolts and the steering column opening lower finish panel reinforcement.
6. Disconnect the clockspring electrical connectors at the base of the steering column and detach the connectors from the bracket.
7. NOTE: Make sure the road wheels are in the straight-ahead position.
Remove the steering wheel.
8. If equipped, loosen the tilt wheel shank handle and remove.
9. Remove the ignition switch lock cylinder.
1
Position the lock cylinder to RUN.
2
Using a suitable tool, push upward on the cylinder release tab through the hole in the lower shroud while pulling the cylinder outward.
10. Remove the 3 screws and the lower steering column shroud.
11. Remove the upper steering column shroud.
12. NOTE: Do not allow the clockspring to turn from its removal position if the clockspring is being reused.
If reusing the clockspring, tape the clockspring center rotor to the outer housing to keep it from rotating.
