E 450 V10-6.8L (2008)
9. Install the upper steering column shroud.
10. Install the lower steering shroud and the 3 screws.
11. Install the ignition switch lock cylinder.
-
Position the ignition switch lock cylinder to the RUN position.
-
Insert the ignition switch lock cylinder into the steering column housing.
-
Make sure the ignition switch lock cylinder is fully seated and aligned in the inter-locking washer before turning the key to the OFF position.
This will permit the retaining pin of the ignition switch lock cylinder to extend into the hole in the steering column.
12. Rotate the ignition switch lock cylinder, using the key, to make sure of correct mechanical operation in all positions.
13. If equipped, install the tilt wheel shank handle.
14. Install the steering wheel.
15. Connect the clockspring electrical connectors.
-
Install the pin-type retainers into the bracket.
16. Install the steering column opening lower finish panel reinforcement and the 6 bolts.
17. Install the 2 screws and the DLC.
18. On the steering column opening lower finish panel reinforcement, install the electrical connector and the pin-type retainer.
19. Install the steering column opening lower finish panel.
-
Align the steering column opening lower finish panel and push in to seat the retaining clips.
20. Install the driver air bag module.
