E 450 V10-6.8L (2008)
All safety belt shoulder height adjusters
1. NOTE: Inspect the D-ring cover for damage. If damaged or does not remain closed, install a new safety belt retractor. The cover is not
serviceable separately.
Open the D-ring cover.
2. Remove the nut and D-ring.
-
To install, tighten to 40 Nm (30 lb-ft).
LH safety belt shoulder height adjuster
3. Remove the door seat around the upper quarter trim panel.
4. Release the 3 retainers and partially pull aside the upper quarter trim panel to access the safety belt shoulder height adjuster.
RH safety belt shoulder height adjuster
5. Remove the door seat around the B-pillar trim panel.
6. Release the 3 retainers and remove the upper B-pillar trim panel.
All height adjusters
7. Remove the safety belt shoulder height adjuster cover.
8. Remove the 2 bolts and safety belt shoulder height adjuster.
-
To install, tighten to 48 Nm (35 lb-ft).
9. NOTE: Make sure the safety belt webbing is not twisted prior to installation.
To install, reverse the removal procedure.
10. Check the active restraint system for correct operation.
