E 450 V10-6.8L (2008)
8. Remove the 4 backrest-to-cushion outboard bolts.
-
To install, tighten to 75 Nm (55 lb-ft).
9. Separate the cushion and backrest frames.
10. Release the remaining backrest trim cover J-clips.
11. Remove the 4 screws and 2 safety belt guide covers.
12. Remove the 2 safety belt retractor covers.
13. CAUTION: Use care not to tear the foam pad when releasing the backrest trim cover retainers.
Invert the backrest trim cover to the row of fasteners, release and separate the trim cover from the foam pad.
14. Invert the trim cover up the backrest and remove.
-
Route out the safety belts.
15. Remove the backrest foam pad.
LH safety belt retractor
16. Remove the 2 screws and safety belt guide bracket.
-
To install, tighten to 10 Nm (89 lb-in).
17. Remove the bolt and LH center safety belt retractor.
-
To install, tighten to 51 Nm (38 lb-ft).
RH safety belt retractor
18. Remove the 2 screws and safety belt guide bracket.
-
To install, tighten to 10 Nm (89 lb-in).
19. Remove the bolt and RH center safety belt retractor.
-
To install, tighten to 51 Nm (38 lb-ft).
LH or RH safety belt retractor
20. To install, reverse the removal procedure.
21. Check the active restraint system for correct operation.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
-
Verify the safety belt retractor operates without excessive effort or binding.
Safety Belt Retractor - Second Row, Outboard
SAFETY BELT RETRACTOR - SECOND ROW, OUTBOARD
Exploded View
