E 450 V10-6.8L (2008)
4. NOTE: Depending on the paint markings, there are 2 methods of indexing the driveshaft and the output shaft.
Install the driveshaft.
1) Preferred method - align the factory-made paint marks on the output shaft and driveshaft and position the driveshaft in the transmission.
2) Alternate method - align the index marks and position the driveshaft in the transmission.
5. NOTE: The driveshaft flange yoke fits tightly on the pinion flange pilot. To make sure that the yoke seats squarely on the flange, tighten the bolts
evenly in a cross pattern in the sequence shown.
Position the driveshaft flange yoke on the pinion flange with the index marks aligned and install the 4 new driveshaft-to-pinion flange bolts.
^
Tighten the new bolts to 112 Nm (83 lb-ft).
