E 450 V10-6.8L (2008)
Transmission Speed Sensor: Service and Repair
Output Shaft Speed (OSS) Sensor
4R70E/4R75E - Automatic Transaxle/Transmission
Output Shaft Speed (OSS) Sensor
Output Shaft Speed (OSS) Sensor
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Disconnect the output shaft speed (OSS) sensor electrical connector.
3. Remove the OSS sensor bolt and sensor.
^
Remove the OSS sensor bolt.
^
Remove the OSS sensor.
4. To install, reverse the removal procedure.
^
Tighten bolt to 12 Nm (9 lb-ft).
Torqshift - Automatic Transaxle/Transmission
Output Shaft Speed (OSS) Sensor