E 450 V8-6.0L DSL Turbo VIN P (2004)
Sliding Door Latch: Adjustments
LATCH CABLE ADJUSTMENT - SLIDING DOOR
Gauge, Door Latch Cable
SPECIAL TOOL(S)
1. NOTE: This adjustment is used to set up the inside and outside handle travel when opening the sliding door. This procedure must be carried out
when a new latch remote control is installed or when the door cannot be opened due to insufficient handle travel.
Remove the sliding door trim panel and watershield.
2. Loosen the sliding door rear latch cable adjusting bolt.
3. WARNING: A spacer block is required for correct adjustment of the latch lever to its correct position. Any adjustment without the use
of this spacer block is not recommended. The rear latch lever could be incorrectly positioned, which could cause a hazard during normal
operation of the vehicle. Failure to follow these instructions may result in personal injury.
With the sliding door rear latch installed in the door, insert the special tool between the cable ferrule and the latch.
