E 450 V8-6.0L DSL Turbo VIN P (2004)
9. To install, reverse the removal procedure.
E-450
Brake Pads-E-450
Special Tool(s)
Material
Removal
1. Remove sufficient brake fluid from the brake master cylinder reservoir to allow for fluid displacement if the caliper pistons need to be bottomed in
the caliper bores.
2. Remove the tire and wheel assembly.
3. Set up the caliper locking pin drive-out.
1
Set the notched end of the Brake Caliper Pin Remover at a 45° angle against the end of the upper caliper locking pin.
2
Tap the tool to squeeze the caliper locking pin so the retention tabs can clear the support bracket.
