E 450 V8-6.0L DSL Turbo VIN P (2004)
10. Install the following components:
1
Install the nut retainer.
2
Install the cotter pin.
3
Install the hub grease cap.
11. Install the brake caliper anchor plate.
E-250, E-350, E-450
Brake Disc E-250, E-350, E-450
Material
Removal
1. Remove the front disc brake caliper anchor plate.
2. Remove the brake disc and hub as follows:
1
Remove the hub grease cap.
2
Remove the cotter pin.
3
Remove the nut retainer.
4
Remove the spindle nut.
5
Remove the front wheel outer bearing retainer washer.
6
Remove the outer front wheel bearing.
7
Remove the brake disc and hub.
3. If necessary, resurface the brake disc and hub. Ford recommends on-vehicle brake disc machining. Follow the lathe manufacturer's instructions.
1
Remove the wheel hub grease seal.
