E 450 V8-6.0L DSL Turbo VIN P (2004)
See Figure 1.
1.
Remove the engine cover from inside the passenger compartment.
2.
Disconnect the EP sensor.
3.
While holding the tube nut remove the EP sensor.
4.
Install the new EP sensor and tighten to 10 Nm (89 lb-in).
5.
Remove the tape from the vehicle harness back to the original take-out location.
6.
CAUTION: The replacement connector has only one color wire, so location identification is crucial for a proper repair.
Label the wires identifying the cavity in which they are located. Place identifying tags at least a few inches away from the connector to be cut off.
