E 450 V8-6.0L DSL Turbo VIN P (2004)
Seat Belt Height Adjuster: Service and Repair
General Procedures
SAFETY BELT SHOULDER HEIGHT ADJUSTER WITH STRIPPED WELD NUTS
D-Ring Installation Kit
SPECIAL TOOL(S)
1. Remove the shoulder safety belt height adjuster
2. Use the half-inch drill with integral stop provided in the D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.
3. NOTE: After each rotation, back off the tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.
Apply a suitable lubricant to the M14 x 1.5 tap with integral stop provided in the D-Ring Installation Kit, and tap new threads.
4. Use a threaded insert provided in the D-Ring Installation Kit and screw it into the retapped hole until it is slightly below the surface.
