E 450 V8-6.0L DSL Turbo VIN P (2004)
Voltage Regulator: Service and Repair
VOLTAGE REGULATOR
REMOVAL
1. Remove the generator.
2. Remove the generator brush and terminal holder and the voltage regulator.
3. Separate the generator brush and terminal holder from the voltage regulator.
1
Remove the screw cap.
2
Remove the screws.
3
Separate the generator brush and terminal holder from the voltage regulator.
INSTALLATION
1. Install the brush and terminal holder on the voltage regulator.
1
Position the brush and terminal holder on the voltage regulator.
2
Install the screws.
3
CAUTION: Make sure screw cap is installed over Test Terminal A to prevent accidental shorting of the battery positive (B+)
connection.
Install the screw cap.