E 450 V8-6.0L DSL Turbo VIN P (2004)
Material
Removal
1. With the vehicle in NEUTRAL position it on a hoist.
2. Remove the driveshaft.
3. Remove the transmission insulator and retainer-to-crossmember retaining nuts.
4. Install the high lift transmission jack with the special tool to the transmission.
5. CAUTION: Be sure not to raise the back of the transmission too high, if it makes contact with the underbody, damage to the TSS and OSS
sensors will occur.
Remove the rear transmission mount.
1. Raise the transmission up off the rear crossmember support.
2. Remove the bolts.
3. Remove the rear transmission mount.
