E 450 V8-6.0L DSL Turbo VIN P (2004)
6. NOTE:This vehicle uses a special extension housing similar to 4x4.
NOTE:As the fasteners are removed, note the size of each for correct location during installation.
Remove the extension housing.
1. Remove the eight bolts.
2. Remove the stud.
3. Remove the extension housing.
7. Remove and discard the extension housing gasket.
Installation
1. CAUTION: The extension must have a shoulder or a boss cast in it to hold the orifice lube plug in the back of the case. If the wrong extension
housing is used the plug may become loose and/or fall out and cause transmission damage.
NOTE: Lightly lubricate the gasket with petroleum jelly to hold it in place during assembly.
Install the new extension housing gasket.
^
Verify that the extension has a shoulder cast in it.
^
Install the new extension housing gasket.
2. NOTE: Make sure the fasteners are installed in their correct locations as noted during removal.
Install the extension housing.
1. Install the extension housing.
2. Install the eight bolts.
3. Install the stud.
