E 450 V8-6.0L DSL Turbo VIN P (2004)
3. Remove the four bolts.
4. Remove the driveshaft.
5. Use the special tools, remove the extension housing seal.
Installation
1. NOTE: If the extension housing seal is equipped with a drain hole, the hole must be pointing down during installation.
Using the special tool, install the new extension housing seal.
2. NOTE: The output shaft and the driveshaft are a balanced assembly.
Install the driveshaft.
^
Align the index marks and position the driveshaft on the transmission.
^
Position the driveshaft to the rear differential.