E 450 V8-6.0L DSL Turbo VIN P (2004)
5. NOTE: The output shaft and the driveshaft are a balanced assembly.
Install the driveshaft.
^
Align the index marks and position the driveshaft on the transmission.
^
Position the driveshaft to the rear differential.
6. NOTE: To maintain driveshaft balance, install the driveshaft yoke and flange in the original position that was marked during removal.
Install the driveshaft.
1. Install the driveshaft.
2. Install the bolts.
Manual Control Lever Shaft and Seal
Manual Control Lever Shaft and Seal
Special Tool(s)
Removal and Installation
CAUTION: Use care not to damage the manual control lever shaft bore. The new seal can leak.
CAUTION: Discard the outer manual control lever nut.
NOTE: When removing the manual control lever shaft retaining pin, use a soft cloth to protect the surface of the case.
1. With the vehicle in NEUTRAL, position it on a hoist.
