E 450 V8-6.0L DSL Turbo VIN P (2004)
2. Slide the small opening end of the slip-yoke boot on the driveshaft stub shaft, as far as it will travel.
3. Using the special tool, crimp the driveshaft slip-yoke boot clamp.
4. Install the driveshaft slip-yoke on the driveshaft.
1
Pull the slip-yoke boot toward the drive shaft. Lubricate the drive shaft splines with approximately 10 grams (0.24 oz) of lubricant.
2
Position the new large slip-yoke boot clamp.
3
Align the blind splines, and install the driveshaft slip-yoke on the driveshaft.
5. Set the driveshaft assembled length to specification.
1
Remove any excess grease from the slip-yoke boot and driveshaft slip-yoke surfaces.
2
Position the slip-yoke boot in the slip-yoke boot groove.
3
Set the driveshaft assembled length to specification.
^
Measure from the stub shaft weld to the U-joint centerline.
4
Bleed the air from the slip-yoke boot.