E 450 V8-6.0L DSL Turbo VIN P (2004)
Transmission Speed Sensor: Service and Repair
TorqShift Automatic Transmission
Turbine Shaft Speed (TSS) Sensor and Intermediate Shaft Speed Sensor
Turbine Shaft Speed (TSS) Sensor and Intermediate Shaft Speed Sensor
REMOVAL
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Install a suitable high-lift transmission jack.
3. Remove the two wire harness retainers from the rear crossmember and position the wire harness out of the way.
4. Remove the LH crossmember nuts.
5. Remove the LH crossmember bracket.
6. Remove the RH crossmember nuts.
7. Remove the RH crossmember bracket.
8. Lower the transmission enough to gain access to the turbine shaft speed (TSS) sensor and intermediate shaft speed sensor.
9. Disconnect the intermediate shaft and turbine shaft combination speed sensor electrical connector.
