Econoline E150 1/2 Ton V6-4.2L VIN 2 (1998)
Air Bag(s) Arming and Disarming: Service and Repair
Arming and Disarming
DEACTIVATION PROCEDURE
1. Disconnect the battery ground cable(s).
WARNING: TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY
MUST BE DEPLETED BEFORE REPAIRING OR REPLACING ANY AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
COMPONENTS. TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE
AND WAIT ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF EQUIPPED).
2. Wait one minute for the backup power supply in the air bag Electronic Crash Sensor (ECS) module to deplete its stored energy.
3. Remove the driver air bag module from the vehicle.
WARNING:
-
CARRY A LIVE AIR BAG MODULE WITH THE AIR BAG AND TRIM COVER POINTED AWAY FROM YOUR BODY. THIS
WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN ACCIDENTAL DEPLOYMENT.
-
DO NOT SET A LIVE AIR BAG MODULE DOWN WITH THE TRIM COVER FACE DOWN.
4. Connect an air bag simulator to the vehicle harness at the top of the steering column.
5. Disconnect the passenger air bag module electrical connector.
6. Connect an air bag simulator to the vehicle harness.
7. Reconnect the battery ground cable(s).
REACTIVATION PROCEDURE
1. Disconnect the battery ground cables.
WARNING: THE AIR BAG SIMULATORS MUST BE REMOVED AND THE AIR BAG MODULES RECONNECTED WHEN THE
SYSTEM IS REACTIVATED TO AVOID NON-DEPLOYMENT IN A COLLISION RESULTING IN POSSIBLE PERSONAL
INJURY.
2. Wait one minute for the backup power supply in the air bag Electronic Crash Sensor (ECS) module to deplete its stored energy.
3. Remove the air bag simulator from the vehicle harness connector at the top of the steering column.
4. Install the driver air bag module.
WARNING: CARRY A LIVE AIR BAG MODULE WITH THE AIR BAG AND TRIM COVER POINTED AWAY FROM YOUR
BODY THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN ACCIDENTAL DEPLOYMENT.
5. Remove the air bag simulator from the vehicle harness connector at the passenger air bag module.
6. Reconnect the passenger air bag module.
7. Reconnect the battery ground cable(s).
8. Prove out the system.
