Econoline E150 1/2 Ton V8-4.6L SOHC VIN W (2001)
6. CAUTION: Do not allow the disc brake caliper to hang from the front brake hose. Use wire to support the disc brake caliper from a convenient
underbody component.
Remove the disc brake caliper from the front wheel spindle (E-150) or from the front disc brake caliper anchor plate (E-250, E-350, E-450).
7. Inspect:
^
the disc brake caliper for brake fluid leakage. If the disc brake caliper is leaking, it must be rebuilt or installed new.
^
the pad thickness. Do not install pads worn to or past the specified thickness above the metal backing plate or rivets.
^
the pads for contamination. Do not put oil- or grease-contaminated pads on vehicle.
^
the brake disc and hub for minimum thickness. Install a new brake disc and hub if worn to or below minimum thickness.
Installation
1. NOTE: Bottoming of the caliper piston is not necessary if reusing the original pads.
If installing new pads, use a C-clamp and a pad to press the caliper piston to the bottom of the caliper bore.
