Econoline E150 1/2 Ton V8-4.6L SOHC VIN W (2001)
Brake Rotor/Disc: Service and Repair
Disc - E-150
Removal
1. Remove the pads.
2. Remove the brake disc and hub as follows:
1
Remove the hub grease cap.
2
Remove the cotter pin.
3
Remove the nut retainer.
4
Remove the spindle nut.
5
Remove the front wheel outer bearing retainer washer.
6
Remove the outer front wheel bearing.
7
Remove the brake disc and hub.
3. If necessary, resurface the brake disc and hub. Ford recommends on-vehicle brake disc machining. Follow the lathe manufacturer's instructions.
1
Remove the wheel hub grease seal.
2
Remove the inner front wheel bearing.
Installation
1. Thoroughly clean and inspect the front wheel bearings and the brake disc and hub.
^
Use Metal Brake Parts Cleaner F3AZ-19579-SA or equivalent.
2. Lubricate the front wheel bearings.
^
Use Premium Long-Life Grease XG-I-C or -K or equivalent meeting Ford specification ESA-MIC75-B.
