Econoline E150 1/2 Ton V8-4.6L SOHC VIN W (2001)
5. Install the high lift transmission jack with the special tool to the transmission.
6. CAUTION: Be sure not to raise the back of the transmission too high, if it makes contact with the underbody, damage to the TSS and OSS
sensors will occur. Remove the rear transmission mount.
1
Raise the transmission up off the rear crossmember support.
2
Remove the bolts.
3
Remove the rear transmission mount.
7. Remove the Vehicle Speed Sensor (VSS).
1
Disconnect the VSS electrical connector.
2
Remove the bolt.
3
Remove the VSS.
8. NOTE: This vehicle uses a special extension housing similar to 4x4.
NOTE: As the fasteners are removed, note the size of each for correct location during installation.
