Econoline E150 1/2 Ton V8-4.6L SOHC VIN W (2001)
Remove the extension housing.
1
Remove the eight bolts.
2
Remove the stud.
3
Remove the extension housing.
9. Remove and discard the extension housing gasket.
Installation
1. CAUTION: The extension must have a shoulder or a boss cast in it to hold the orifice lube plug in the back of the case. If the wrong extension
housing is used the plug may become loose and/or fall out and cause transmission damage.
NOTE: Lightly lubricate the gasket with petroleum jelly to hold it in place during assembly.
Install the new extension housing gasket.
-
Verify that the extension has a shoulder cast in it.
-
Install the new extension housing gasket.
2. NOTE: Make sure the fasteners are installed in their correct locations as noted during removal.
Install the extension housing.
1
Install the extension housing.
2
Install the eight bolts.
3
Install the stud.
3. Install the vehicle speed sensor (VSS).
1
Install the VSS.
2
Install the bolt.
3
Connect the electrical connector.