Econoline E150 1/2 Ton V8-4.6L SOHC VIN W (2001)
2. CAUTION: Damage will occur to the rubber-coated sealing washers and transmission fluid will leak if the cooler line case fittings are
overtightened.
NOTE: Align the rubber-coated sealing washers while installing CBV assembly on the transmission case.
Install the CBV assembly.
3. Install the fluid cooler tube in the front cooler bypass valve assembly fitting and in the rear cooler line case fitting.
4. CAUTION: Install a new inline transmission fluid filter (XC3Z-7BI55-BA) every 48,000 km (30,000 miles) and always as part of a transmission
overhaul or exchange. If the vehicle was not equipped with an inline fluid filter install a new inline transmission fluid filter kit (XC3Z-7Bl55-AA)
according to the instructions supplied with the kit as part of a transmission overhaul or exchange.
CAUTION: Failure to follow the instructions supplied with the inline transmission fluid filter kit can cause transmission damage.
CAUTION: Verify that the flow arrow on the filter points toward the transmission.
Install a new inline transmission fluid filter (XC3Z-7Bl55-BA). If the vehicle was not equipped with an inline fluid filter, install a new inline
transmission fluid filter kit (XC3Z-7Bl55-AA) according to the instructions supplied with the kit. Carry out the transmission fluid cooler flow test
procedure to verify that there is correct fluid flow through the new inline fluid filter.
5. Lower the vehicle.
6. CAUTION: MERCON(R) Automatic Transmission Fluid is being replaced by MERCON(R) V as a service fluid, per TSB 06-14-4.
Fill the transmission with the specified type and quantity of transmission fluid. .
-
Use Motorcraft MERCON V Multipurpose (ATF) Transmission Fluid XT-5-QM or equivalent meeting MERCON V specifications.
7. Check for leaks.
