Econoline E150 1/2 Ton V8-4.6L SOHC VIN W (2001)
Transmission Mode Switch: Service and Repair
Selector Lever
Selector Lever
Removal
1. Remove the instrument panel cluster opening finish panel assembly.
2. Remove the ignition switch lock cylinder.
1
Position the lock cylinder to RUN.
2
Using a suitable too], push upward on the cylinder release tab through the hole in the lower shroud while pulling the cylinder outward.
3. Remove the upper steering column shroud.
4. Remove the transmission range selector lever. Disconnect the electrical connector.
Installation
1. NOTE: Install a new transmission range selector lever pin whenever it is removed.