ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Alignment|Specifications > < Wheel Alignment - Procedures For Incomplete Vehicles|Page 1497
Page 10
background image

6.

Verify the vehicle no longer dogtracks by rerunning the Diagnostic Procedure.

SUPERSEDES: 00-5-10

WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage

OPERATION

DESCRIPTION

TIME

021608A

Correct Thrust Angle Or

1.6 Hrs.

Rear Axle

DEALER CODING

CONDITION

BASIC PART NO.

CODE

4210

42

OASIS CODES: 303000 304000, 305000, 390000

Technical Service Bulletin # 98-17-12

Date: 980901

Wheel Alignment - Procedures For Incomplete Vehicles

Article No.
98-17-12

09/01/98

ALIGNMENT - ALIGNMENT PROCEDURES FOR 
INCOMPLETE VEHICLES - SERVICE TIP

LIGHT TRUCK: 
1998 ECONOLINE

ISSUE

Wheel alignment on incomplete vehicles is not reimbursable.

ACTION

After build-up of incomplete vehicles, realign vehicles to factory specification. Setting vehicles to factory specification should resolve all alignment
issues. Refer to the following text for details.

INCOMPLETE VEHICLES (Cut-Away, Strip Chassis)

Wheel alignment on incomplete vehicles (cut-away, strip chassis) is not reimbursable due to installation of special bodies or equipment after the vehicles
leave the assembly plant. If readjustment is necessary, follow the instructions in the 1998 Econoline Workshop Manual to reset the alignment back to
OEM specification. The cost for such realignment is the responsibility of the final stage manufacturer or modifier.

INCOMPLETE VEHICLES (Conversion Vans)

On incomplete vehicles (conversion vans), toe must be checked by the final stage manufacturer and is not reimbursable. Should toe readjustment be
necessary, follow the instructions in the 1998 Econoline Workshop Manual to reset the alignment to OEM specification. The cost for such realignment is
the responsibility of the final stage manufacturer or modifier. Note that occasionally van conversions will require additional adjustments (i.e., caster and
camber). If such adjustments are required, they are reimbursable per the Warranty and Policy Manual.

OTHER APPLICABLE ARTICLES: NONE

WARRANTY STATUS: INFORMATION ONLY

OASIS CODES: 306000

Alignment|Specifications > < Wheel Alignment - Procedures For Incomplete Vehicles|Page 1497