Econoline E150 1/2 Ton V8-5.4L CNG VIN M (1998)
Axle Beam: Service and Repair
Axle Pivot Bushing
REMOVAL
1. Remove the front coil spring for the affected front axle.
2. Remove the bolt and lower the pivot end of the front axle.
NOTE: In order to obtain clearance for pivot bolt removal when servicing the RH front axle, it may be necessary to raise the LH side of the
vehicle to relieve the weight on the suspension.
3. Using the Forcing Screw, Bushing Remover and Receiver Cup, remove the axle pivot bushing.
INSTALLATION
1. Position the new pivot bushing
-
Position spacing washers, the Receiver Cup, Forcing Screw, Bushing Replacer, and the new pivot bushing on the front axle.
CAUTION: The new pivot bushing must be free of grease, oil or other contamination.
NOTE: The flanged end of the pivot bushing faces the front of the vehicle.
