Econoline E250 3/4 Ton V6-4.2L VIN 2 (1998)
Blower Motor Resistor: Service and Repair
Blower Motor Resistor
REMOVAL
1. If equipped, remove the third, fourth, and fifth bench seats as required.
2. If equipped, remove the trim panels.
-
Remove the left center bolster trim panel.
-
Remove the quarter trim rear upper panel.
-
Remove the lower rear body side trim panel.
3. Disconnect the heater blower motor switch resistor connector.
4. Remove the heater blower motor switch resistor.
1. Remove the screws.
2. Remove the heater blower motor switch resistor.
INSTALLATION
1. Follow the removal procedure in reverse order.