Econoline E350 1 Ton V10-6.8L VIN S (1998)
Tie Rod End: Service and Repair
Replacement
REMOVAL
NOTE: Replace the ball stud if loose in the steering control bail stud socket or the tie rod end is bent. Replace the front suspension steering ball stud
dust seal if any nicks, cuts or tears are present. Do not attempt to straighten a bent tie rod end.
1. Raise the vehicle on a hoist, with the wheels in the straight-ahead position.
2. Remove the tie rod end castle nut.
(1) Remove the cotter pin.
(2) Remove the nut.
3. Using the Pitman Arm Puller, remove the ball stud from the front wheel spindle.
4. Remove the tie rod end.
(1) Loosen the nuts on the tie rod adjusting sleeve.
(2) Count the number of turns while removing the tie rod end from the tie rod adjusting sleeve.
5. Remove the tie rod adjusting sleeve. Count the number of turns required to remove the tie rod adjusting sleeve clamp.
INSTALLATION
1. Follow the removal procedure in reverse order. Make sure the adjuster clamps are in the correct position.
NOTE: The two bolts and nuts on the tie rod adjusting sleeve clamp for the tie rod end must be positioned within a limit of 45 degrees (±). The
threaded ends of the bolts on the left tie rod end point toward the front of the vehicle. The threaded ends on the right tie rod end face rearward.
