Econoline E350 1 Ton V8-5.4L CNG VIN M (1999)
Position the front pump support with the splines up.
2. Mount (A) torque converter on the (B) front pump support with the splines on the one-way clutch inner race, engaging the mating splines of the
front pump support.
3. Hold the (A) front pump support stationary and rotate the (B) torque converter counterclockwise.
^
The torque converter should rotate freely with no signs of scraping.
^
If there are signs of scraping, replace the torque converter.
Stator to Turbine Interference Check
1. NOTE: Front pump support may remain in front pump support and gear during this test.
Position the torque converter with the pump drive up.
2. Install the (A) front pump support to engage the mating splines of the front pump support shaft on the (B) torque converter.
3. Install the forward clutch cylinder and shaft engaging the splines with the rear clutch hub.
