Econoline E350 1 Ton V8-5.4L Prop SOHC VIN Z (1998)
Disconnect the SCDS and inspect the harness connector (See Figure 3) for the presence of brake fluid.
^
All vehicles except 1993 Mark VIII: If there is no evidence of brake fluid on the connector, install a Fused Jumper Harness.
-
On 1993 Mark VIII vehicles with no evidence of brake fluid on the SCDS harness connector, replace the Speed Control Deactivation Switch but
do not inspect or apply electrical grease to the speed control servo connector.
^
If there is evidence of brake fluid on the connector, replace the Speed Control Deactivation Switch, inspect and apply electrical grease to the
appropriate connectors.
FUSED JUMPER HARNESS (FJH) INSTALLATION
1.
Connect the fused jumper harness to the SCDS and the vehicle harness.
2.
Secure the jumper harness to the existing harness with tie straps, making sure the fuse holders are positioned vertically with the cap facing upward.
Wrap the tie straps underneath, then over the top of the existing harness and verify proper fuse holder orientation. See Figure 4.
SPEED CONTROL DEACTIVATION SWITCH (SCDS) REPLACEMENT
NOTE:
The brake pedal must not be depressed during the removal and replacement of the SCDS.
1.
Check the brake fluid level at the master cylinder and, if necessary, fill to maximum fluid level.
NOTICE:
DO NOT apply fluid to the electrical connector or damage to the connector may occur.
NOTICE:
The 1994 Capri Brake Repair Kit contains a brass sealing washer. Install the brass washer onto the SCDS before installing it on the vehicle.
