Econoline E350 1 Ton V8-5.4L SOHC VIN L (1999)
4.
Insert a 14 mm hex key (Allen) wrench into the hollow oil filter mounting stud. Remove the stud from the center of the oil cooler. See Figure 4.
5.
Remove the oil cooler and oil cooler-to-adapter seal.
6.
Making certain the new oil cooler-to-adapter seal is in place, install the new oil cooler. Make sure the notch in the oil cooler is lined up with the
tang on the oil filter adapter. See Figure 5. Tighten the hollow oil filter mounting stud to 57 Nm (42 lb-ft).
7.
Connect the cooler hoses.
8.
Remove the clamps from the cooler hoses.
9.
Install a new oil filter.
10.
Lower the vehicle and go to Engine Oil and Coolant Condition Check.
ENGINE OIL AND COOLANT CONDITION CHECK
1.
Inspect the engine oil for signs of engine coolant, such as a white milky substance, by removing and inspecting the dipstick. Inspect the coolant
recovery reservoir for signs of engine oil. If the cooling system is contaminated, the inside wall of the reservoir will be coated with engine oil,
leaving a dark residue.
^
If the engine oil or coolant is contaminated, change the engine oil. Go to Cooling System Flush.
