Econoline E350 1 Ton V8-5.4L SOHC VIN L (1999)
Tires: Service and Repair
Single Wheels
Removal
1. Remove the wheel cover, if so equipped.
2. CAUTION: Do not use heat to loosen a seized lug nut. Heat can damage the wheel and wheel bearings.
NOTE: Do not remove the lug nuts at this time.
With the weight of the vehicle still on the tires, loosen the lug nuts.
3. Raise the vehicle until the wheel and tire assembly clears the floor.
4. Remove the lug nuts.
5. Remove the wheel and tire assembly.
Installation
1. WARNING: When a wheel is installed, always remove any corrosion, dirt or foreign material present on the mounting surfaces of the
wheel or the surface of the front disc brake hub and rotor that contacts the wheel. Installing wheels without proper metal-to-metal
contact at the wheel mounting surfaces can cause the lug nuts to loosen and the wheel to come off while the vehicle is in motion, resulting
in loss of control.
Position the wheel and tire assembly on the vehicle.
2. Install the lug nuts loosely. Make sure the cone ends of the lug nut face inward.
3. Turn the wheel until one lug nut is at the top of the wheel hub bolt circle. Tighten the lug nut until snug. In a crisscross-type pattern, tighten the
remaining lug nuts until snug to minimize runout.
4. Lower the vehicle.
5. CAUTION: Failure to tighten the lug nuts in a star pattern can result in high rotor runout, which will speed up the development of brake
roughness, shudder and vibration.
Tighten the lug nuts to specification.
6. Install the wheel cover, if equipped.
