ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Fluid - A/T|4R70W|Page 4973 > < Fluid - A/T|Capacity Specifications|Page 4970
Page 1
background image

Fluid - A/T: Service and Repair
4R70W

Fluid Change-Drain/Refill 

Normal maintenance requires periodic automatic transmission fluid changes. If a major service, such as a clutch, band, bearing, etc., is required, the
automatic transmission fluid will also have to be removed for service. At this time, the, transmission cooler, cooler inlet tube and cooler tube must be
thoroughly flushed to remove any dirt. When used under continuous or severe conditions, the transmission and should be drained and refilled with
fluid.

Normal Maintenance 

No recommended changes

Special Operating Conditions 

1. Change fluid at 48,000 km (30,000 miles) 

2. CAUTION:  Use of a fluid other than specified could result in transmission malfunction and/or failure.

Refer to the vehicle certification label affixed to the LH front door lock face panel or door pillar for the transmission code.

3. When filling a dry transmission, refer to Specifications for capacity. Check the fluid level.

Removal 

1. Raise and support the vehicle.
2. Place a drain pan under the transmission fluid pan.

3. Drain the transmission fluid.

^

Loosen the transmission fluid pan bolts and allow the fluid to drain. After the fluid is drained remove the bolts.

4. Remove the (A) and the (B) transmission pan gasket.

^

Replace transmission pan gasket as necessary.

Fluid - A/T|4R70W|Page 4973 > < Fluid - A/T|Capacity Specifications|Page 4970