Econoline E350 1 Ton V8-5.4L SOHC VIN L (1999)
Position the differential housing cover on the rear axle.
1
Install the differential housing cover.
2
Install the 10 differential housing cover bolts.
4. CAUTION: For Traction-Lok(R) axles, first fill the rear axle with 115 ml (4 oz) of specified Ford Friction Modifier.
NOTE: Service refill capacities are determined by filling the rear axle to the level shown.
Fill the rear axle with 2.4 liters (5.5 pints) of Motorcraft Synthetic Rear Axle Lubricant F1TZ-19580-B or equivalent meeting Ford specification
WSL-M2C192-A and install the filler plug.
5. Lower the vehicle.
9.75 Inch Ring Gear
Removal
1. Raise and support the vehicle.
2. NOTE: Empty the lubricant into a clean container for reuse.
Remove the differential housing cover.
1
Remove the 12 bolts, and drain the lubricant from the rear axle housing.
2
Remove the differential housing cover.
Installation
1. CAUTION: Make sure the machined surfaces on both the rear axle housing and the differential housing cover are clean and free of oil before
applying the new silicone sealant. The inside of the rear axle must be covered when cleaning the machined surface to prevent contamination.
Clean the gasket mating surface of the rear axle and the differential housing cover.
