Econoline E350 1 Ton V8-5.4L SOHC VIN L (1999)
Remove the driveshaft from the U-Joint Tool, and install the snap ring.
3. Repeat Steps 1 and 2 to install the opposite side of the driveshaft yoke.
4. Inspect the driveshaft slip-yoke. Install a new yoke, if necessary.
5. Repeat Steps 1 and 2 to install the remaining new bearing cups, spider, driveshaft slip-yoke, and the snap rings
6. NOTE: Do not strike the bearings.
Check the U-joints for freedom of movement.
^
If binding, strike the yoke with a brass or plastic hammer.
7. Install the driveshaft.
