Econoline E350 1 Ton V8-7.3L DSL Turbo VIN F (1998)
2. Place the rocker arm pedestal on the steel ball and the rocker arm.
3. Snap the retaining clip over the rocker arm pedestal groove.
4. Lubricate the push rod ends with engine oil and install the push rod, copper end up.
5. Rotate the engine until the mark on the crankshaft damper is at 11 o'clock, to prevent valve damage when installing the intake rocker arm and
exhaust rocker arm.
CAUTION: Make sure to follow the next step of this procedure to prevent bent valves.
6. Install the push rods, position the intake rocker arm and exhaust rocker arm, and install the rocker arm bolts.
7. Install the rocker arm cover gasket.
8. Connect the electrical connectors to the fuel injectors and glow plugs.
9. Install the valve cover and retaining bolts.
10. Connect the engine harness electrical connectors to the valve cover gasket.
